MidNite Solar Classic 150-SL Charge Controller (SKU Part Number Classic 150-SL)

The classic SL-150 MPPT charge controller is a simplified solar only version of the classic 150 with streamlined menus. the classic SL-150 has a graphics panel and ground fault but no arc fault or ethernet capabilities. the classic SL-150 has a maximum output current of 96 amps, an operating voltage of 150 volts and works with 12 to 72 volt battery systems. as with the whole classic line, the classic SL-150 has midnite's exclusive hypervoc which extends voc limits when needed.. with a streamlined menu, these solar only MPPT charge controllers are easy to setup and a breeze to install.

Features

• Exclusive HyperVOC Extends VOC Limits
• Built in DC-Ground Fault Protection
• Optional Battery Sensor for temperature correction on battery charging
• Type 1 environmental rating
• Low Battery Voltage disconnect and re-connect of loads fully programmable with 2 auxiliary output to control external load disconnect/re-connect switch
• Hyper VOC standard all models - extended VOC range for cold climates
• Arc fault protection - standard on classic, 0.25 seconds detect and trip speed
• Ground fault protection - standard all models - resettable, no fuse to blow

Specifications

• Nominal Battery Voltage: 72 V
• Maximum Output Current:
  • 96 A on 12 V
  • 94 A on 24 V
  • 86 A on 48 V
• PV Open Circuit Voltage (VDC): 150 V
• Power Conversion Efficiency: 98%
• Maximum Standby Self Consumption: 2.8-4 W
• Reverse Current at Night: Zero (Internal Relay for Reverse Current)
• Type of Charging/Charging Regulation: Bulk, Absorb, Float & Equalization
• Battery Voltage Regulation Set Points: 10-100 VDC
• Equalization Charging: Adjustable Voltage & Duration, Manual or Auto
• PV Reverse Polarity: Protected to Maximum VOC
• Battery Reverse Polarity: Fully Protected
• Battery Over Voltage: Fully Protected
• Battery Short Circuit: Fully Protected
• Battery Temperature Compensation:
  • Automatic when BTS is Installed
  • Adjustable mV per °C per 2 V Cell
• Programmable Auxiliary Control Output:
  • 2 Auxiliary Outputs
  • Auxiliary 1: 12 V Out or Dry Connect
  • Auxiliary 2: 12 V Out or Logic N
• Graphic Display: Yes
• Networking Cabling: Standard 4-Conductor Phone Cable, No Hub Needed
• Communication: ModBus Openly Published over Ethernet & RS232
• Remote Display:
  • Display (MNGP) can be Relocated
  • Second Display can be Added
• Terminal Rating: 75°C
• Internal Ready: All Models
• Data Logging:
  • 380 Days of Daily History
  • 24 Hours of Data at 5-Minute Intervals
• Operating Temperature: -40 to 50°C
• Environmental Rating: IP30
• Conduit Knockout:
  • Single 1 in Conduit on Left & Right Sides
  • Two 1 in Conduits on Bottom
  • Two 3/4 in Conduits on Back
• Standards: ETL Listed, CE Certified
• Warranty: 5 Years
• Dimensions: 14.9 in x 6 in x 4 in
• Weight: 12 lb

Documents 

• Specification Sheet