Tamarack Solar 2-inch Tee-Fitting. Use 1 for each vertical post

The Tamarack ground mount system is assembled using 3.1 rail with 2-in schedule 40 or 80 galvanized steel pipe that is purchased separately. Use four 66-in rails and two structural splices per column to create two 132-in rail assemblies for 3 modules per column. Use four 85 in and two structural splices per column to create two 170-in rail assemblies for 4 modules per column. The maximum PV module width is 41.5 in on 4 module columns and 43 in on 3 module columns. The system comes with all parts needed except for the 2-in pipe and concrete. Assembly is quick and easy and can be used on almost any terrain.

Features

• Simple design - Arrays can be in columns of 3 or 4 module high and any width required
• Easy to install - No welding or drilling and two wrench sizes fit all fasteners
• UL 2703 Listed - All components meet the UL 2703 standards for bonding and grounding
• PE certified - Pre-stamped engineering letters available for most states
• Easy to configure - Unlimited system size with tilt angles from 0 to 45 degrees
• Visually appealing - Simple to adjust for perfect alignment, even if the surface is irregular
• Simple wire management - PV cables and wiring for module-level electronics fits inside rails to avoid time-consuming wire management
• Extremely robust - For use in locations with wind speeds up to 170 Mph and ground snow loads of up to 70 Psf
• Connect vertical 2 in pipe to horizontal 2 in pipe
  

Specifications

• Size: 2 in
  
• Material: Aluminum
  
• Suitable For Use With: Tamarack Modular Ground Mount

Documents 

• Specification Sheet
• Instruction/Installation Manual